Download  Print this page

Installing The Card - Mitsubishi Electric apricot MS660 Owner's Handbook Manual

Hide thumbs

Advertisement

E x p a n s i o n c a r d s

Installing the card

5/6
MS660 OWNER'S HANDBOOK
between C8000h and DFFFF in upper memory. With most
modern expansion cards this is fully automatic.
The card's documentation should list its possible base memory
addresses. You will also need to know how much memory the card
has, so that you can leave the right gap between this card's base
address and the next.
Cards often come with pre-configured or default settings. It is best
to rely on these settings as much as possible, and change them only
if they conflict with other devices.
Installing expansion cards can be one of the most difficult
operations you may ever perform within your computer. If you are
in any doubt, or come into difficulties you are unable to resolve,
contact the supplier of the expansion card or ask your Apricot dealer
for advice or assistance.
1.
Turn off the computer and unplug all power cords. Take
suitable anti-static precautions and remove the system side and
top panels. Detailed information is given in chapter 1.
Note
Note
If you are unfamiliar with the recommended anti-static precautions,
refer to the antistatic section at the rear of this handbook.
2.
At the rear of the system unit are metal blanking plates, one for
each expansion card slot. To ensure the front edge of a full
length card is securely supported you will find card guides on
the front of the machine on the rear of the fan assembly.
3.
First decide in which of the available slots you wish to install
the card. Note that some cards will only fit in certain slots.
4.
Remove the blanking plate of the chosen slot by removing its
securing screw, then sliding the blanking plate out of its slot.
Keep the screw, it will be needed later to secure the card.

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: