Changing The Output Destination For Previews - Sony RCP-1500 Operation Manual

1 Turn the adjustment knob on the far left to change the
RCP number.
Note
If an RCP number is duplicated, the equipment will not
function normally. Be sure to set a number that will not be
a duplicate of that of another MCS.
[Set]
2 Press .
11
[Exit]
Press .
The Network screen reappears.
12
Set the TCP/IP.
[TCP/IP]
1 Press .
The TCP/IP screen appears.
TCP/IP
IP Address
168 0 1
192
Subnet Mask
255 255 0
255
Default GW
0 0 0
0
Set Cancel
2 Set the IP address, subnet mask, and default gateway.
Press the corresponding input field, and then use the
numeric keypad on the screen to enter the information.
[Set]
3 Press .
13
[Exit]
Press .
The Network screen reappears and the control panel is
set to MCS mode.
Changing the Output Destination for
Previews
The output destination of the key signals for previews of the
control panel can be changed.
1
Enter engineer mode. (page 52)
2
Press the MENU button.
The menu closes and the control panel remains in
engineer mode.
3
Display the RCP Config screen. (page 51)
RCP Config
Display
Customize
/Sound
Date
Network
/Time
Exit
7 8 9
4 5 6
1 2 3
BS 0 Enter
Exit
VR
Mode
Setting
Infor-
Security
mation
Backup
4
[Mode]
Press .
The RCP Mode screen appears.
RCP Mode
Screen
PIX/WF
Saver
Preview
5
[Preview]
Press .
The Preview screen appears.
Preview
Preview
CNU
RCP CCU
S-BUS
6
Press a button to select the output destination.
[RCP]
: EXT I/O connector of the RCP unit
[CCU]
: External output connector of the CCU
[CNU S-BUS]
: S-BUS system via the CNU
Exit
Matrix Extend
Gate Call
Exit
Installation
35