Setting Security Restrictions; To Set The Security Level - Sony RCP-1500 Operation Manual

6
Select the cursor type displayed on the monitor.
[H Cursor]
: Press this to light the button and turn the
horizontal cursor ON.
[V Cursor]
: Press this to light the button and turn the
vertical cursor ON.
[H/V Cursor]
: Press this to light the button and turn the
horizontal and vertical cursors ON.
7
Move the cursors on the monitor to the position you
want to correct.
Turning the adjustment knobs move the cursors on the
monitor. Based on the cursor type selected in step 6, the
horizontal or vertical cursor or both will be assigned to the
adjustment knobs.
RPN Correction
R G
H/V
H Cursor V Cursor
Cursor
H Cursor V Cursor
500 157ev
8
[Enter]
Press .
The cursor position is set, and the RPN Correction screen
changes to the following.
RPN Correction
H Cursor V Cursor
Cursor
Exit
B Enter
Exit
Delete
H/V
Save Cancel
Level
99
9
Turn the adjustment knob on the far right to correct
the defect on the monitor.
Turning the adjustment knob right increases the
brightness level, and turning it left decreases the
brightness level. View the monitor and perform
adjustments until the defects are not visible.
RPN Correction
H/V
H Cursor V Cursor
Cursor
10
[Save]
Press .
The brightness correction value is registered to the control
panel.
To set a different correction value, press
the previous value, and repeat the procedure from step 9.
11
[Exit]
Press .
The brightness correction value is registered to the control
panel.

Setting Security Restrictions

To set the security level

You can restrict the control functions of the control panel if
necessary.
1
Enter engineer mode. (page 52)
Security
Code
Page Item
Permission Permission Change
ALL
Preset
2
Set the security level.
The settings for the security level are split into two
screens. Press each of the buttons to display each setting
screen and configure the security level settings.
Exit
Delete
Save Cancel
Level
99
[Delete]
to delete
Exit
Engeneer
Mode
41
Settings