Setting Bridge Mode - Sony RCP-1500 Operation Manual

5
[CNS]
Press .
The CNS screen appears.
CNS
Legacy
Mode:Semi-Auto
Bridge
Target:
192.168.0.1
Mode:Master
MCS
Master:
192.168.0.1
RCP No. 96
6
[LEGACY]
Press .
7
[Set]
Press .
The control panel is set to LEGACY mode.

Setting BRIDGE Mode

Set the control panel to BRIDGE mode when connecting the
control panel and a camera device on a LAN on a one-to-one
basis. The TCP/IP needs to be set in BRIDGE mode. The IP
address of the connection target camera device also needs to
be set in the RCP or MSU. The RCP number does not need to
be set. Multi-camera operation is not possible in BRIDGE
mode.
1
Enter engineer mode. (page 52)
2
Press the MENU button.
The menu closes and the control panel remains in
engineer mode.
3
Display the RCP Config screen. (page 51)
RCP Config
Display
Customize
/Sound
Date
Network
/Time
4
[Network]
Press .
The Network screen appears.
Network
Network
CNS
Info
Exit
Set
Edit
Cancel
Edit
Exit
VR
Mode
Setting
Infor-
Security
mation
Backup
Exit
LAN I/F TCP/IP
5
[CNS]
Press .
The CNS screen appears.
CNS
Legacy
Mode:Semi-Auto
Bridge
Target:
192.168.0.1
Mode:Master
MCS
Master:
192.168.0.1
RCP No. 96
6
[Bridge]
Press .
7
[Set]
Press .
The control panel is set to BRIDGE mode.
8
Set the connection mode.
[Edit]
1 Press .
The Bridge Mode Set screen appears.
Bridge Mode Set
Connection Mode
Semi-
Active Passive
auto
Target
192 168 0 1
Set Cancel
2 Press a button to set the sub mode of BRIDGE mode.
Set the sub mode in accordance with the connection
state.
[Active]
: Performs the process to connect to the
target by itself.
[Passive]
: Waits for a connection from the target.
[Semi-auto]
: Switches between Active and Passive
depending on the connection environment. Active
is enabled when the RCP stands alone, and
Passive is enabled when the RCP is connected to
a CCU or camera via a CCA-5 cable.
9
Set the IP address of the connection target camera
device.
1 Set the target IP address.
Press the IP address input field, and then use the
numeric keypad on the screen to enter the IP address.
[Set]
2 Press .
10
[Exit]
Press .
The CNS screen reappears.
11
[Exit]
Press .
The Network screen reappears.
12
Set the TCP/IP.
Exit
Set
Edit
Cancel
Edit
Exit
7 8 9
4 5 6
1 2 3
BS 0 Enter
Installation
33