Sony RCP-1500 Operation Manual page 76

To set the return input settings
[Return Settings]
Select
formats of return signals from the CCU.
Return Settings
Return 1 1080/59.94i (PsF)
Return 2
Return 3
1080/59.94i (PsF)
Return 4
Use the following procedure to set the settings.
1
[Return-1]
Press any one of
The screen for specifying the format of the return signal
appears.
Return Settings
Input
Return 1
Return 2
Return 3
Return 4
2
Set the format of the return signal.
[Input]
: Specifies the input signal.
[Aspect]
: Specifies the aspect ratio. This can only be set
if you specified SD signal for
[LB Mode]
: Specify the display mode for letter box if you
specified [Letter Box] for
The setting values that can be selected for each setting
value are displayed in a list. Turn the adjustment knob on
the very left to move the cursor to select a setting value.
3
[Enter]
Press .
The settings for the format of the return signal are
changed.
4
Repeat steps 1 to 3 if you also want to set the
remaining return signals.
76
Menus
in the CONFIG menu to set the
Exit
Input Aspect LB Mode
NTSC Squeeze
Letter
NTSC 16:8
Box
[Return-4]
to .
Exit
LB
Aspect
Mode
Enter Cancel
[Input]
.
[Aspect]
.
To control the CCU menu
[CCU Menu Control]
Select in the CONFIG menu to remotely
control the menu displayed for image output of the CCU from
this control panel.
CCU Menu Control
Menu Disp
[Menu Disp]
• Use to display or hide the CCU menu.
The setting menu appears when this button is pressed even
when CHARACTER display is enabled for image output of
the CCU. In such a case, closing the setting menu redisplays
the CHARACTER display.
[Enter]
• Press to switch to the setting mode and confirm
changing of the setting value.
[Cancel]
• Press to end the setting mode and cancel
changing of the setting value.
• Turn the adjustment knob on the very left to move the cursor
in the CCU menu and change a setting value.
Exit
Enter
Cancel