Fuji Xerox DocuPrint C4350 User Manual page 348

C Precautions/Limitations
Configuring the computer
Take great care when setting the IP address. The IP address is managed
●
throughout the system. Consult your network administrator before defining any
address.
Consult the Network Information Service (NIS) administrator when setting the
●
network (such as the IP address) by a host being used under NIS.
Switching off the power
Note the following points when switching off the power of this printer:
When [LPD Spool] is set to [Memory]
All print data spooled to the printer memory, including data in the process of
printing, will be deleted. When the power is turned on again, the print data will
not be found.
However, if the power switch is off immediately after the print data has been
sent, the print data may be stored in the computer. In this case, when the power
is turned on again, the stored print data will be printed first even if new print data
has been sent.
When [LPD Spool] is set to [Hard Disk]
All print data spooled to the Hard Disk Drive of this printer, including data in the
process of printing, will be saved. When the power is turned on again, the stored
print data will be printed first even if new print data has been sent.
When [LPD Spool] is set to [Off].
All print data spooled to the receive buffer of this printer, including data in the
process of printing, will be deleted. When switching on the power again, the print
data will not be found.
However, if the power is switched off immediately after the print data has been
sent, the print data may be stored in the computer. In this case, when switching
on the power again, the stored print data will be printed first even if new print
data has been sent.
Printing
When [LPD Spool] is set to [Hard Disk], or [Memory]´
If the print data is larger than the Hard Disk Drive or the remaining memory
capacity at the point of receiving print data, the data will not be received.
When the print data has exceeded the receiving capacity, some computers may re-send the data imme-
diately. When this occurs, the computer appears as if it had crashed. To rectify the situation, stop the
computer from sending print data.
320