Fuji Xerox DocuPrint C4350 User Manual page 299

SNMP
Set when using SNMP. You need to set the SNMP server to use an application, which controls print-
ers remotely. Information from the printers is under control by the SNMP server, and the application
collects information on the printers from the SNMP server.
■Port Startup
Set the status of the SNMP port to enabled or disabled when the power is switched on. The default is
[Enable], to use SNMP.
If memory becomes insufficient when the port is set to [Enable], the status of the port may be automatically set
to [Disable]. Select the status of the unused port to [Disable] or change the memory allocation capacity at
[Allocate Memory], in case of insufficient memory.
■Transport Protocol
Set the protocol of the transport levels of SNMP. You can use either IPX or UDP, or both of them.
The default is [UDP].
IP Address is needed on both the computer and the printer to use UDP.
●
Refer to the manual for the application software, to know which protocol to use.
●
■Community (R)
Set a community name for reading the control information (MIB) on the printer. You can set 1-12
alphanumeric characters. The default is [Unregistered].
■Community (R/W)
Set a community name for reading the control information (MIB) on the printer. You can set 1-12
alphanumeric characters. The default is [Unregistered].
■Community (Trap)
Set a community name for the Trap using 1-12 alphanumeric characters. The default is [Unregis-
tered].
TCP/IP Setting
■IGet IP Address
Set to obtain necessary information in order to use TCP/IP (IP address, subnet mask, and gateway
address) from the Dynamic Host Configuration (DHCP) server, the DHCP/Autonet server, the
BOOTP server, or the RARP server, automatically or manually. Contact the network administrator to
set the IP address manually. The default is [DHCP/Autonet]. A connectable DHCP server is
searched. If no DHCP server is available, this machine allocates an address.
If [Manual] is specified from [DHCP/Autonet], [DHCP], [BOOTP], or [RARP], an IP address setting screen is
displayed for manual setting.
■IIP Address, Subnet Mask, Gateway Address (Note 3) (P.289)
You can use these functions to check the IP Address, which has been obtained automatically, and to
set the IP Address manually. Enter the IP address in a xxx.xxx.xxx.xxx format. xxx refer to the value
between 0 to 255.
7.2 Description of Common Menu
7
271