Fuji Xerox DocuPrint C4350 User Manual page 291

LPD
Set when using LPD.
■Port Startup
Set the status of the LPD port to [Enable] or [Disable] when switching on the power. The default is
[Enable], which allows the use of the LPD port.
To activate the LPD port, need to set the IP address.
When the port is set to [Enable], and if there is insufficient memory, the status of the port may automatically be
reset to [Disable]. Set unused port status to [Disable] or change the memory allocation capacity at [Allocate
Memory], in case of insufficient memory.
■Print Mode (Note 1) (P.301)
Set the process method (targeted print language) of the print data.
The optional values are as follows:
[Auto] (default)
The proper process is automatically selected according to the language of the data received from the
computer.
[PS] [ESC/P] [HP-GL/2] [PCL] [TIFF]
Data received from the computer is processed.
■PJL (LOOK 2) (P.301)
With this printer, you can use the [PJL] command, which does not depend on any print language. The
PJL command controls the print job, and is necessary when you use the print driver. Setting the status
of the PJL command sent from the computer enables or disables it. By using the PJL command, you
can select the print language for the next data, even if the printer is under another process in any print
language. Set [Enable] for normal use. The default is [Enable].
■Connect Time-out (Note 3) (P.301)
Set the time to cut the connection from 2 to 3600 seconds, in 1 second increments while receiving
data. The default is [16Secs].
■TBCP Filter
Set the TBCP filter to enabled or disabled, while data from the PostScript is processed. The default is
[Disable].
■Port No.
Specify the port number in the range of 8000 to 9999. The default is [515].
7.2 Description of Common Menu
7
263