Fuji Xerox DocuPrint C4350 User Manual page 301

Ethernet
Set the communication speed and the type of the connector for the Ethernet interface.
The optional values are as follows:
[Auto] (default)
The machine is switched to 100M full duplex, 100M half duplex, 10M full duplex, or 10M half
duplex automatically.
[100M Full Dup]
Select for 100M full duplex only.
[100M Half Dup]
Select for 100M half duplex only.
[10M Full Dup]
Select for 10M full duplex only.
[10M Half Dup]
Select for 10M half duplex only.
IPX/SPX Frame Type
Set the active frame type of IPX/SPX.
The optional values are as follows:
[Auto] (default)
Set the frame type automatically.
[Ethernet II]
Use the frame type specified for Ethernet.
[Ethernet 802.3]
Use the frame type specified for IEEE802.3.
[Ethernet 802.2]
Use the frame type specified for IEEE802.3/IEEE802.2.
[Ethernet SNAP]
Use the frame type specified for IEEE802.3/IEEE802.2/SNAP.
Filter
■IP Filter
Set whether to limit the reception IP address for printing. When [On] is set, a printing job cannot be
processed except from registered IP addresses. The default is [Off].
In case the registered IP address is all 000. 000. 000. 000, the command is disabled even if [On] is selected.
■IP Address (Note 1) (P.289)
To limit acceptable IP addresses, register the IP address from which to receive print jobs. Up to 10 IP
addresses can be registered. The address mask is set for the registered IP address. Enter the IP
address and the address mask in a xxx.xxx.xxx.xxx format. xxx refer to the value between 0 to 255.
For example, if you set the [IP Address]: [129.249.110.23], [IP Address Mask]: [255.255.255.0],
the accepted IP addresses are [129.249.110* (1 to 254)].
7.2 Description of Common Menu
7
273