Fuji Xerox DocuPrint C4350 User Manual page 297

Port9100
Set when using Port9100.
■Port Startup
Set the status of the Port9100 port to enabled or disabled when the power is switched on. The default
is [Disable]. Set [Enable] when you use Port9100.
To activate the port9100 port, need to set the IP address.
If memory becomes insufficient when the port is set to [Enable], the status of the port may be automatically set
to [Disable]. Set the status of the unused port to [Disable], or change the memory allocation capacity at [Allo-
cate Memory], in case of insufficient memory.
■Print Mode (LOOK 1) (P.289)
Set the process method (targeted print language) of the print data.
The optional values are as follows:
[Auto] (default)
The proper process is automatically selected according to the language of the data received from the
computer.
[PS] [ESC/P] [HP-GL/2] [PCL] [TIFF]
Data received from the computer is processed.
■PJL (LOOK 2) (P.289)
You can use the PJL command with this printer, which does not depend on any print language. The
PJL command controls the print job, and is necessary when you use the print driver. Set the status of
the PJL command sent from the computer to enabled or disabled. By using the PJL command, you
can select the print language for the next data, even if the machine is under another process in any
print language. Set [Enable] for normal use. The default is [Enable].
■Connect Time-Out (Note 1) (P.289)
Set the time to cut the connection from 2 to 65535 seconds, in 1 second increments while receiving
data. The default is [60 Secs].
■Port No.
Set the port number in the range of 1 to 65535. The default is [9100].
■TBCP Filter
Set the TBCP filter to enabled or disabled, while data from the PostScript is processed. The default is
[Disable].
UPnP
Set when using Universal Plug and Play (UPnP).
■Port Startup
Set the status of the UPnP port to enabled or disabled when the power is switched on. The default is
[Disable]. Set [Enable] when you use UPnP.
If memory becomes insufficient when the port is set to [Enable], the status of the port may be automatically set
to [Disable]. Set the status of the unused port to [Disable], or change the memory allocation capacity at [Allo-
cate Memory], in case of insufficient memory.
■Port No.
Select the port number in the range of 1 to 65535. The default is [80].
7.2 Description of Common Menu
7
269