Setting The Gateway Id - Motorola RG2200 User Manual

Residential gateway

Hide thumbs Also See for RG2200:

Table of Contents

ETTING THE

ATEWAY

Depending upon the model of the remote control, instructions are as follows.

1. Press the LED key and hold it down until the LED

flashes rapidly.

2. Press the REC key. The LED stops blinking at this point

and stays on solid.

3. Press the B key. The remote is now in programming

mode. You can set the GATEWAY ID.

4. Enter the 3-digit code assigned to your RG2200. The

valid range is 004 - 999 for SRC-300s in native mode.

For SRC-300s in SRC-200 Compatibility mode, the

range is 004 - 255. Enter a number with 3-digits, even if

it contains leading zeroes. Examples of valid values are:

009, 012, 354, or 988.

If you entered the Gateway ID correctly, the LED blinks several times. If the value was not entered successfully, the LED

goes off and the remote control returns to normal operation. Repeat the steps above to try again. See

Gateway ID" on page 34

SRC-300

to verify the Gateway ID.

1. Press the B key and hold it down until the LED at the

top of the remote flashes rapidly.

2. Release the B key.

3. Enter the following three key sequence: 7-8-9. The

remote is now in programming mode. You can set the

GATEWAY ID.

4. Enter the 3-digit code assigned to your RG2200. The

valid range is 004 - 255. You must enter a number with

3-digits, even if it contains leading zeroes. Examples of

valid values are: 009, 012, 124, or 255.

SRC-200

"Determining the

Table of Contents