Motorola RG2200 User Manual page 70

Problem
No picture
No picture
Picture is distorted
Blue or black TV screen
Snowy picture on all TVs
Only one stereo speaker
has sound
70
Possible Cause
TV or RG2200 may not be acti-
vated.
Cable signal may not be reach-
ing your home.
VCR may be set incorrectly.
Your RG2200 has recently
received a software download.
Sometimes after a download the
system fails to operate. You may
need to restart your RG2200.
Coaxial cable is disconnected or
loose.
No video supplied to TV.
VCR is on at this location and TV
is on wrong channel.
TV is on wrong channel for
Source.
Audio connections are loose.
Refer to "Getting Started" on page
Make sure all cables are connected properly and that your TV is tuned to the correct RF
channel (for example 6,7, or 13) for the TV you are using (TV-1, TV-2, or TV-3). If the
baseband video output on the RG2200 is connected to the VIDEO IN input on the TV,
make sure the TV is set to the correct video input.
Check to see how the VCR is connected to the RG2200. If the baseband video output
on the RG2200 is connected to the VCR, the VCR must be ON and programmed to
VIDEO IN.
Make sure VCR/TV is set to TV.
Make sure the TV is set to the correct TV or video input.
To restart your RG2200, press and hold down the power button on the front panel for 5
seconds.
Reconnect or tighten the cable.
If VCR is connected using RCA jacks, VCR must be ON to provide picture.
Call your NSP to reset your RF channel.
Call your NSP to reset your RF channel.
Reconnect audio connections.
Check to make sure that no wires are frayed and no plugs are bent or broken.
Try This
15.