To Replace The Control Slide Knob; To Remove The Burner Unit; To Remove The Electronic Ignition Generator - Valor Dream Fireslid 9500433 Installer's Manual

Valor 600B610_01 7/12/00
microswitch leads and pull the leads
clear of the thermocouple interrupter
block (see figure 26).
Detach the bridging bracket, microswitch
10.2.4
assembly and insulation pad by
removing two screws (see figure 25).
Replace in the reverse order. When
10.2.5
refitting the leads to the interrupter block,
make sure that they are secured firmly to
give a good electrical contact.

To replace the control slide knob

10.3
Remove the front fascia casting by lifting
10.3.1
up and forward free from the case
location brackets.
Detach the slider knob from the slider bar.
10.3.2
See figure 27.
figure 27
Slider knob attatchment
Refit in the reverse order.
10.3.3

To remove the burner unit

10.4
Remove the "ash pan" casting and bottom
10.4.1
front casting.
Remove the loose coals, the front base
10.4.2
coal, rear base coal and front burner trim.
Disconnect the control linkage by
10.4.3
removing the knurled screw which
connects the control linking bar to the
control pivot unit (see figure 28).
Support the inlet isolating elbow to avoid
10.4.4
straining the pipework and disconnect the
appliance from the elbow.
Detach the burner unit from the
10.4.5
convection box by removing two screws
(see figure 29). Lift the burner unit clear.
3:23 PM Page 16
INSTALLER GUIDE
figure 28
10.4.6
figure 29
10.5
10.5.1
10.5.2
10.5.4
10.5.5
10.5.6
Page 16
Control linkage
Refit in the reverse order. Make sure that
the tab at the right side of the
battery box is in front of the "L" shaped
bracket which projects up from the fire
case base. See figure 29.
Burner fitting
To remove the electronic ignition
generator
Remove the burner unit- See section 10.4
Remove the battery.
Remove the two leads to the switch and
remove the spark lead, marking them
if necessary to ensure that they are
replaced on to the correct terminals.
Remove the two fixing screws that attach
the generator unit to the bracket. The
igniter generator can now be exchanged.
Refit in the reverse order. When refitting
the burner unit, make sure that the tab
at the right side of the battery box is in
front of the "L" shaped bracket which