Control Slide Button; Control Slide Unit; Electronic Ignition Generator - Valor 4190 Installer's Manual

13.4A To replace the control slide button - Ultimate Fireslide front
13.4A.1 Remove the front surround - See section 13.3.
13.4A.2 Swing the rear shield plate towards the centre to access the back of the
button. (See fig. 41).
13.4A.3 Remove the screw securing the slide button to the back of the slide
unit. Pull the centre pin out of the plastic plug which is securing the slide
button and then remove the plug (See fig. 41). Raise the slide button so that it
clears the slide bar and pull it through the slot in the surround side).
13.4A.4 Refit in the reverse order. See section 13. 3. 6 for refitting the
surround.
13.4B To replace the control slide button - Fusion front
13.4B.1 Remove the front surround - See section 13.3.
15.4B.2 Detach the rear shield plate by removing two screws from the rear
right side of the front surround (See fig. 42).
15.4.3 Remove the two screws securing the slide button to the back of the slide
mechanism bar. Raise the button to clear the bar and pull through the slot in
the surround side (See fig. 42).
15.4.4 Refit in the reverse order.
Fig. 41 Control slide unit -
Ultimate Fireslide front
13.5A To remove the control slide unit - Ultimate Fireslide front
13.5A.1 Remove the surround unit and slide button - see sections 13.3 &
13.4A
13.5A.2 Remove the four screws securing the plastic slide mechanism angle
bracket to the rear side of the surround (See figure 41). Lift the slide unit
clear.
13.5A.3 Refit in the reverse order. See section 13. 3. 6 for refitting the
surround.
13.5B To remove the control slide unit - Fusion front
13.5B.1 Remove the surround unit and slide button - see sections 13.3 &
13.4B
13.5B.2 Remove the two screws securing the plastic slide mechanism box
to the rear side of the surround. Lift the slide unit clear.
13.5B.3 Refit in the reverse order. See section 13. 3. 6 for refitting the
surround.
Fig. 42 Control slide unit -
Fusion front
13.6 To remove the electronic ignition generator
For the majority of installations, the ignition generator can be removed as
described below. However, if the installation has a front left side gas
connection, the gas supply line will have to be disconnected and the burner
removed - see section 13.8
13.6.1 Remove the bottom front cover and the fire front casting.
13.6.2 Remove the battery.
13.6.3 Remove the two screws securing the ignition generator bracket to the
burner unit, the screw holding the inlet pipe clamp and the screw attaching the
bracket to the bottom of the convection box (See figure 43). Carefully lift the
bracket (with the ignition generator and leads) clear.
13.6.4 Detach the ignition lead from the electrode.
13.6.5 Detach the ignition generator from the bracket by removing two screws.
13.6.6 Detach the two ignition microswitch leads from the electronic ignition
generator.
13.6.7 Refit in the reverse order.
Fig. 43 Ignition generator removal
25