Table of Contents
Advertisement
Valor 600B610_01
7/12/00
Burner Trim Fitting
6.8
Position the burner trim over the front
flanges of the burner tray and firmly push
it down as far as it will go. See figure 13.
figure 13
Burner trim fitting
Fascia Fitting
6.9
Locate the four fascia tabs fully over the
slotted brackets on the convection box
front face. See figure 14.
figure 14
Fascia location
7.CERAMIC COALS
INSTALLATION
Place the front base coal in the burner
7.1
compartment so that it rests on the
ledges at the sides and front. Pull
the coal forward so that it is immediately
behind the front rim of the burner
compartment. See figure 15.
3:22 PM
Page 11
INSTALLER GUIDE
figure 15
7.2
figure 16
7.3
figure 17
Page 11
Front base coal
Place the rear base coal in the burner
compartment behind the front coal. It
should rest on the ledge at the back of the
burner compartment. The projections at
the sides of the rear coal should touch the
front coal. See figure 16.
Rear base coal
Place one of the loose coals from the bag
in the centre of the front base coal. Make
sure that it bridges the space between the
front and rear base coals. See figure 17.
First loose coal
Hide quick links:
Advertisement
Table of Contents
