Snmp - ZyXEL Communications 310 User Manual

Table 189 Configuration > System > FTP (continued)
LABEL
Remove
Move
#
Zone
Address
Action
Apply
Reset

37.11 SNMP

Simple Network Management Protocol is a protocol used for exchanging management information
between network devices. Your ZyWALL supports SNMP agent functionality, which allows a manager
station to manage and monitor the ZyWALL through the network. The ZyWALL supports SNMP
version one (SNMPv1) and version two (SNMPv2c). The next figure illustrates an SNMP
management operation.
ZyWALL 110/310/1100 Series User's Guide
DESCRIPTION
To remove an entry, select it and click Remove. The ZyWALL confirms you want to remove
it before doing so. Note that subsequent entries move up by one when you take this action.
To change an entry's position in the numbered list, select the method and click Move to
display a field to type a number for where you want to put it and press [ENTER] to move
the rule to the number that you typed.
This the index number of the service control rule.
The entry with a hyphen (-) instead of a number is the ZyWALL's (non-configurable)
default policy. The ZyWALL applies this to traffic that does not match any other configured
rule. It is not an editable rule. To apply other behavior, configure a rule that traffic will
match so the ZyWALL will not have to use the default policy.
This is the zone on the ZyWALL the user is allowed or denied to access.
This is the object name of the IP address(es) with which the computer is allowed or denied
to access.
This displays whether the computer with the IP address specified above can access the
ZyWALL zone(s) configured in the Zone field (Accept) or not (Deny).
Click Apply to save your changes back to the ZyWALL.
Click Reset to return the screen to its last-saved settings.
Chapter 37 System
479