Snmp - ZyXEL Communications ZyWALL 1100 User Manual

Table 283 Configuration > System > FTP (continued)
LABEL
Remove
Move
#
Zone
Address
Action
Apply
Reset

34.11 SNMP

Simple Network Management Protocol is a protocol used for exchanging management information
between network devices. Your ZyWALL/USG supports SNMP agent functionality, which allows a
manager station to manage and monitor the ZyWALL/USG through the network. The ZyWALL/USG
supports SNMP version one (SNMPv1) and version two (SNMPv2c). The next figure illustrates an
SNMP management operation.
Chapter 34 System
DESCRIPTION
To remove an entry, select it and click Remove. The ZyWALL/USG confirms you want to
remove it before doing so. Note that subsequent entries move up by one when you take
this action.
To change an entry's position in the numbered list, select the method and click Move to
display a field to type a number for where you want to put it and press [ENTER] to move
the rule to the number that you typed.
This the index number of the service control rule.
The entry with a hyphen (-) instead of a number is the ZyWALL/USG's (non-configurable)
default policy. The ZyWALL/USG applies this to traffic that does not match any other
configured rule. It is not an editable rule. To apply other behavior, configure a rule that
traffic will match so the ZyWALL/USG will not have to use the default policy.
This is the zone on the ZyWALL/USG the user is allowed or denied to access.
This is the object name of the IP address(es) with which the computer is allowed or denied
to access.
This displays whether the computer with the IP address specified above can access the
ZyWALL/USG zone(s) configured in the Zone field (Accept) or not (Deny).
Click Apply to save your changes back to the ZyWALL/USG.
Click Reset to return the screen to its last-saved settings.
ZyWALL/USG Series User's Guide
649