ZyXEL Communications 310 User Manual page 101

Figure 72 Monitor > Log
The following table describes the labels in this screen.
Table 36 Monitor > Log
LABEL
Show Filter / Hide Filter
Display
Priority
Source Address
Destination Address
Source Interface
Destination Interface
Service
Keyword
Protocol
Search
ZyWALL 110/310/1100 Series User's Guide
DESCRIPTION
Click this button to show or hide the filter settings.
If the filter settings are hidden, the Display, Email Log Now, Refresh, and Clear
Log fields are available.
If the filter settings are shown, the Display, Priority, Source Address,
Destination Address, Service, Keyword, and Search fields are available.
Select the category of log message(s) you want to view. You can also view All Logs
at one time, or you can view the Debug Log.
This displays when you show the filter. Select the priority of log messages to
display. The log displays the log messages with this priority or higher. Choices are:
any, emerg, alert, crit, error, warn, notice, and info, from highest priority to
lowest priority. This field is read-only if the Category is Debug Log.
This displays when you show the filter. Type the source IP address of the incoming
packet that generated the log message. Do not include the port in this filter.
This displays when you show the filter. Type the IP address of the destination of the
incoming packet when the log message was generated. Do not include the port in
this filter.
This displays when you show the filter. Select the source interface of the packet that
generated the log message.
This displays when you show the filter. Select the destination interface of the packet
that generated the log message.
This displays when you show the filter. Select the service whose log messages you
would like to see. The Web Configurator uses the protocol and destination port
number(s) of the service to select which log messages you see.
This displays when you show the filter. Type a keyword to look for in the Message,
Source, Destination and Note fields. If a match is found in any field, the log
message is displayed. You can use up to 63 alphanumeric characters and the
underscore, as well as punctuation marks ()' ,:;?! +-*/= #$% @ ; the period,
double quotes, and brackets are not allowed.
This displays when you show the filter. Select a service protocol whose log
messages you would like to see.
This displays when you show the filter. Click this button to update the log using the
current filter settings.
Chapter 6 Monitor
101