Tunnel Add Or Edit Screen - ZyXEL Communications 310 User Manual

Table 50 Network > Interface > Tunnel (continued)
LABEL
Status
Name
IP Address
Tunnel Mode
My Address
Remote Gateway
Address
Apply
Reset

7.6.2 Tunnel Add or Edit Screen

This screen lets you configure a tunnel interface. Click Configuration > Network > Interface >
Tunnel > Add (or Edit) to open the following screen.
ZyWALL 110/310/1100 Series User's Guide
DESCRIPTION
The activate (light bulb) icon is lit when the entry is active and dimmed when the entry
is inactive.
This field displays the name of the interface.
This is the IP address of the interface. If the interface is active (and connected), the
ZyWALL tunnels local traffic sent to this IP address to the Remote Gateway Address.
This is the tunnel mode of the interface (GRE, IPv6-in-IPv4 or 6to4). This field also
displays the interface's IPv4 IP address and subnet mask if it is a GRE tunnel.
Otherwise, it displays the interface's IPv6 IP address and prefix length.
This is the interface or IP address uses to identify itself to the remote gateway. The
ZyWALL uses this as the source for the packets it tunnels to the remote gateway.
This is the IP address or domain name of the remote gateway to which this interface
tunnels traffic.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
Chapter 7 Interfaces
143