ZyXEL Communications 310 User Manual page 138

Chapter 7 Interfaces
Table 49 Configuration > Network > Interface > Cellular > Add (continued)
LABEL
Check Period
Check Timeout
Check Fail
Tolerance
Check Default
Gateway
Check this
address
Check Port
Related Setting
Configure WAN
TRUNK
Configure Policy
Route
IP Address
Assignment
Get
Automatically
Use Fixed IP
Address
IP Address
Assignment
Metric
Device Settings
Network
Selection
138
DESCRIPTION
Enter the number of seconds between connection check attempts.
Enter the number of seconds to wait for a response before the attempt is a failure.
Enter the number of consecutive failures before the ZyWALL stops routing through the
gateway.
Select this to use the default gateway for the connectivity check.
Select this to specify a domain name or IP address for the connectivity check. Enter
that domain name or IP address in the field next to it.
This field only displays when you set the Check Method to tcp. Specify the port
number to use for a TCP connectivity check.
Click WAN TRUNK to go to a screen where you can configure the interface as part of
a WAN trunk for load balancing.
Click Policy Route to go to the policy route summary screen where you can configure
a policy route to override the default routing and SNAT behavior for the interface.
Select this option If your ISP did not assign you a fixed IP address. This is the default
selection.
Select this option If the ISP assigned a fixed IP address.
Enter the cellular interface's WAN IP address in this field if you selected Use Fixed IP
Address.
Enter the priority of the gateway (if any) on this interface. The ZyWALL decides which
gateway to use based on this priority. The lower the number, the higher the priority. If
two or more gateways have the same priority, the ZyWALL uses the one that was
configured first.
This field appears if you selected a 3G device that allows you to select the type of
network to use. Select the type of 3G service for your 3G connection. If you are unsure
what to select, check with your 3G service provider to find the 3G service available to
you in your region.
Select auto to have the card connect to an available network. Choose this option if you
do not know what networks are available.
You may want to manually specify the type of network to use if you are charged
differently for different types of network or you only have one type of network
available to you.
Select GPRS / EDGE (GSM) only to have this interface only use a 2.5G or 2.75G
network (respectively). If you only have a GSM network available to you, you may
want to select this so the ZyWALL does not spend time looking for a WCDMA network.
Select UMTS / HSDPA (WCDMA) only to have this interface only use a 3G or 3.5G
network (respectively). You may want to do this if you want to make sure the interface
does not use the GSM network.
ZyWALL 110/310/1100 Series User's Guide