Ppp Interface Add Or Edit - ZyXEL Communications 310 User Manual

Each field is described in the table below.
Table 45 Configuration > Network > Interface > PPP
LABEL
User Configuration /
System Default
Add
Edit
Remove
Activate
Inactivate
Connect
Disconnect
Object References
#
Status
Name
Base Interface
Account Profile
Apply
Reset

7.4.2 PPP Interface Add or Edit

Note: You have to set up an ISP account before you create a PPPoE/PPTP interface.
This screen lets you configure a PPPoE or PPTP interface. If you enabled IPv6 in the Configuration
> System > IPv6 screen, you can also configure PPP interfaces used for your IPv6 networks on
this screen. To access this screen, click the Add icon or an Edit icon in the PPP Interface screen.
ZyWALL 110/310/1100 Series User's Guide
DESCRIPTION
The ZyWALL comes with the (non-removable) System Default PPP interfaces pre-
configured. You can create (and delete) User Configuration PPP interfaces.
Click this to create a new user-configured PPP interface.
Double-click an entry or select it and click Edit to open a screen where you can modify
the entry's settings.
To remove a user-configured PPP interface, select it and click Remove. The ZyWALL
confirms you want to remove it before doing so.
To turn on an entry, select it and click Activate.
To turn off an entry, select it and click Inactivate.
To connect an interface, select it and click Connect. You might use this in testing the
interface or to manually establish the connection for a Dial-on-Demand PPPoE/PPTP
interface.
To disconnect an interface, select it and click Disconnect. You might use this in testing
the interface.
Select an entry and click Object Reference to open a screen that shows which
settings use the entry. See
This field is a sequential value, and it is not associated with any interface.
The activate (light bulb) icon is lit when the entry is active and dimmed when the entry
is inactive.
The connect icon is lit when the interface is connected and dimmed when it is
disconnected.
This field displays the name of the interface.
This field displays the interface on the top of which the PPPoE/PPTP interface is.
This field displays the ISP account used by this PPPoE/PPTP interface.
Click Apply to save your changes back to the ZyWALL.
Click Reset to return the screen to its last-saved settings.
Section 7.3.2 on page 122
Chapter 7 Interfaces
for an example.
127