ZyXEL Communications 310 User Manual page 46

Chapter 4 Quick Setup Wizards
Figure 27 WAN and ISP Connection Settings: (PPTP Shown)
The following table describes the labels in this screen.
Table 12 WAN and ISP Connection Settings
LABEL
ISP Parameter
Encapsulation
Authentication
Type
User Name
Password
Retype to
Confirm
Nailed-Up
Idle Timeout
PPTP Configuration
Base Interface
Base IP Address
IP Subnet Mask
46
DESCRIPTION
This section appears if the interface uses a PPPoE or PPTP Internet connection.
This displays the type of Internet connection you are configuring.
Use the drop-down list box to select an authentication protocol for outgoing calls.
Options are:
CHAP/PAP - Your ZyWALL accepts either CHAP or PAP when requested by this remote
node.
CHAP - Your ZyWALL accepts CHAP only.
PAP - Your ZyWALL accepts PAP only.
MSCHAP - Your ZyWALL accepts MSCHAP only.
MSCHAP-V2 - Your ZyWALL accepts MSCHAP-V2 only.
Type the user name given to you by your ISP. You can use alphanumeric and -_
characters, and it can be up to 31 characters long.
Type the password associated with the user name above. Use up to 64 ASCII characters
except the [] and ?. This field can be blank.
Type your password again for confirmation.
Select Nailed-Up if you do not want the connection to time out.
Type the time in seconds that elapses before the router automatically disconnects from
the PPPoE server. 0 means no timeout.
This section only appears if the interface uses a PPPoE or PPTP Internet connection.
This displays the identity of the Ethernet interface you configure to connect with a
modem or router.
Type the (static) IP address assigned to you by your ISP.
Type the subnet mask assigned to you by your ISP (if given).
ZyWALL 110/310/1100 Series User's Guide
@$./