ZyXEL Communications 310 User Manual page 153

Table 53 Configuration > Network > Interface > VLAN > Create Virtual Interface (continued)
LABEL
Gateway
Metric
IPv6 Address
Assignment
Enable Stateless
Address Auto-
configuration
(SLAAC)
Link-Local
address
IPv6 Address/
Prefix Length
Gateway
Metric
Address from
DHCPv6 Prefix
Delegation
Add
Edit
Remove
#
Delegated
Prefix
Suffix
Address
Address
ZyWALL 110/310/1100 Series User's Guide
DESCRIPTION
This field is enabled if you select Use Fixed IP Address.
Enter the IP address of the gateway. The ZyWALL sends packets to the gateway when it
does not know how to route the packet to its destination. The gateway should be on the
same network as the interface.
Enter the priority of the gateway (if any) on this interface. The ZyWALL decides which
gateway to use based on this priority. The lower the number, the higher the priority. If
two or more gateways have the same priority, the ZyWALL uses the one that was
configured first.
These IP address fields configure an IPv6 IP address on the interface itself.
Select this to enable IPv6 stateless auto-configuration on this interface. The interface
will generate an IPv6 IP address itself from a prefix obtained from an IPv6 router in the
network.
This displays the IPv6 link-local address and the network prefix that the ZyWALL
generates itself for the interface.
Enter the IPv6 address and the prefix length for this interface if you want to configure a
static IP address for this interface. This field is optional.
The prefix length indicates what the left-most part of the IP address is the same for all
computers in the network, that is, the network address.
Enter the IPv6 address of the default outgoing gateway using colon (:) hexadecimal
notation.
Enter the priority of the gateway (if any) on this interface. The ZyWALL decides which
gateway to use based on this priority. The lower the number, the higher the priority. If
two or more gateways have the same priority, the ZyWALL uses the one that was
configured first.
Use this table to have the ZyWALL obtain an IPv6 prefix from the ISP or a connected
uplink router for an internal network, such as the LAN or DMZ. You have to also enter a
suffix address which is appended to the delegated prefix to form an address for this
interface. See Prefix Delegation on page 107
To use prefix delegation, you must:
• Create at least one DHCPv6 request object before configuring this table.
• The external interface must be a DHCPv6 client. You must configure the DHCPv6
request options using a DHCPv6 request object with the type of prefix-delegation.
• Assign the prefix delegation to an internal interface and enable router
advertisement on that interface.
Click this to create an entry.
Select an entry and click this to change the settings.
Select an entry and click this to delete it from this table.
This field is a sequential value, and it is not associated with any entry.
Select the DHCPv6 request object to use from the drop-down list.
Enter the ending part of the IPv6 address, a slash (/), and the prefix length. The
ZyWALL will append it to the delegated prefix.
For example, you got a delegated prefix of 2003:1234:5678/48. You want to configure
an IP address of 2003:1234:5678:1111::1/128 for this interface, then enter
::1111:0:0:0:1/128 in this field.
This field displays the combined IPv6 IP address for this interface.
Note: This field displays the combined address after you click OK and reopen this
screen.
Chapter 7 Interfaces
for more information.
153