ZyXEL Communications 310 User Manual page 274

Chapter 19 Firewall
Figure 165 Configuration > Firewall > Session Limit
The following table describes the labels in this screen.
Table 100 Configuration > Firewall > Session Limit
LABEL
General Settings
Enable Session
limit
IPv4 / IPv6 Rule
Summary
Default Session
per Host
Rule Summary
Add
Edit
Remove
Activate
Inactivate
Move
Status
#
274
DESCRIPTION
Select this check box to control the number of concurrent sessions hosts can have.
The IPv4 rules apply to IPv4 sessions. The IPv6 rules apply to IPv6 sessions.
Use this field to set a common limit to the number of concurrent NAT/firewall sessions
each client computer can have.
If only a few clients use peer to peer applications, you can raise this number to improve
their performance. With heavy peer to peer application use, lower this number to ensure
no single client uses too many of the available NAT sessions.
Create rules below to apply other limits for specific users or addresses.
This table lists the rules for limiting the number of concurrent sessions hosts can have.
Click this to create a new entry. Select an entry and click Add to create a new entry after
the selected entry.
Double-click an entry or select it and click Edit to open a screen where you can modify the
entry's settings.
To remove an entry, select it and click Remove. The ZyWALL confirms you want to remove
it before doing so.
To turn on an entry, select it and click Activate.
To turn off an entry, select it and click Inactivate.
To change a rule's position in the numbered list, select the rule and click Move to display a
field to type a number for where you want to put that rule and press [ENTER] to move the
rule to the number that you typed.
The ordering of your rules is important as they are applied in order of their numbering.
This icon is lit when the entry is active and dimmed when the entry is inactive.
This is the index number of a session limit rule. It is not associated with a specific rule.
ZyWALL 110/310/1100 Series User's Guide