The Service Group Add/Edit Screen - ZyXEL Communications 310 User Manual

Chapter 29 Services
Table 148 Configuration > Object > Service > Service Group (continued)
LABEL
Family
Name
Description

29.3.1 The Service Group Add/Edit Screen

The Service Group Add/Edit screen allows you to create a new service group or edit an existing
one. To access this screen, go to the Service Group screen (see
click either the Add icon or an Edit icon.
Figure 259 Configuration > Object > Service > Service Group > Edit
The following table describes the labels in this screen.
Table 149 Configuration > Object > Service > Service Group > Edit
LABEL
Name
Description
394
DESCRIPTION
This field displays the Server Group supported type, which is according to your
configurations in the Service Group Add/Edit screen.
There are 3 types of families:
• : Supports IPv4 only
• : Supports IPv6 only
• : Supports both IPv4 and IPv6
This field displays the name of each service group.
By default, the ZyWALL uses services starting with "Default_Allow_" in the firewall rules to
allow certain services to connect to the ZyWALL.
This field displays the description of each service group, if any.
DESCRIPTION
Enter the name of the service group. You may use 1-31 alphanumeric characters,
underscores( ), or dashes (-), but the first character cannot be a number. This value is
_
case-sensitive.
Enter a description of the service group, if any. You can use up to 60 printable ASCII
characters.
Section 29.3 on page
ZyWALL 110/310/1100 Series User's Guide
393), and