Tunnel Add Or Edit Screen - ZyXEL Communications USG40 User Manual

Figure 142 Network > Interface > Tunnel
Each field is explained in the following table.
Table 82 Network > Interface > Tunnel
LABEL
Add
Edit
Remove
Activate
Inactivate
Object References
#
Status
Name
IP Address
Tunnel Mode
My Address
Remote Gateway
Address
Apply
Reset

8.6.2 Tunnel Add or Edit Screen

This screen lets you configure a tunnel interface. Click Configuration > Network > Interface >
Tunnel > Add (or Edit) to open the following screen.
Chapter 8 Interfaces
DESCRIPTION
Click this to create a new GRE tunnel interface.
Double-click an entry or select it and click Edit to open a screen where you can modify
the entry's settings.
To remove an entry, select it and click Remove. The ZyWALL/USG confirms you want
to remove it before doing so.
To turn on an entry, select it and click Activate.
To turn off an entry, select it and click Inactivate.
Select an entry and click Object Reference to open a screen that shows which
settings use the entry. See
This field is a sequential value, and it is not associated with any interface.
The activate (light bulb) icon is lit when the entry is active and dimmed when the entry
is inactive.
This field displays the name of the interface.
This is the IP address of the interface. If the interface is active (and connected), the
ZyWALL/USG tunnels local traffic sent to this IP address to the Remote Gateway
Address.
This is the tunnel mode of the interface (GRE, IPv6-in-IPv4 or 6to4). This field also
displays the interface's IPv4 IP address and subnet mask if it is a GRE tunnel.
Otherwise, it displays the interface's IPv6 IP address and prefix length.
This is the interface or IP address uses to identify itself to the remote gateway. The
ZyWALL/USG uses this as the source for the packets it tunnels to the remote gateway.
This is the IP address or domain name of the remote gateway to which this interface
tunnels traffic.
Click Apply to save your changes back to the ZyWALL/USG.
Click Reset to begin configuring this screen afresh.
ZyWALL/USG Series User's Guide
194
Section 8.3.2 on page 173 for an example.