Configuring System Parameters - Mirage 2000 User Manual

3.7 Configuring
System
Parameters
System Configuration
And Diagnostics
NOTE: This option has no function unless the Stereo3D
By default, the checkbox is checked and the signal inverted.
White Boost
Not available in this projector.
PLL Loop Gain – See description in Size and Position.
Noise Reduction – requires optional ADP Module
Select the amount of image noise reduction desired, with "0" applying no noise
reduction (default) and "10" applying maximum noise reduction. The higher the
value, the softer the image.
Horizontal Filter – requires optional ADP Module
Select the amount of horizontal filtering desired for the current source. Note that the
default setting of "0" allows the projector to optimize the amount of horizontal
filtering according to the current source, and is the recommended setting for most
situations. You can override this by selecting a value from 1-10, with "1" applying no
filtering and "10" applying maximum filtering. High filtering levels will soften the
image slightly, particularly evident along vertical edges.
Vertical Filter - requires optional ADP Module
Select the amount of vertical filtering desired for the current source. Note that the
default setting of "0" allows the projector to optimize the amount of vertical filtering
according to the current source, and is the recommended setting for most situations.
You can override this by selecting a value from 1-10, with "1" applying no filtering
and "10" applying maximum filtering. High filtering levels will soften the image
slightly, particularly evident along horizontal edges.
Use the Configuration menu to
display and/or set global system
operating parameters that are
typically in effect regardless of
source, or to work with other
settings that are not unique to the
current incoming source.
NOTE: For experienced
users/technicians only.
'
In the Configuration menu, you
can define a variety of general system parameters to suit your preferences, run certain
diagnostic tests, and access the Service Menu (password required). Settings in the
Configuration menu will typically apply regardless of the type of source your are
using.
Image Orientation
Use this pull down list to change the orientation of the image according to the
orientation of your projector. If the setting is incorrect, projected images will be
TM
Interface Module is used.
Mirage 2000/4000/6000 User's Manual
OPERATION
3-39