Mirage 2000 User Manual page 127

SPECIFICATIONS
Inputs / Outputs
5-2
Mirage 2000/4000/6000 User's Manual
'
Number of inputs
Analog RGB and YP
Horizontal frequency range *
Vertical frequency range *
Pixel clock rate (digitizing sample rate)
Signal format
Active pixels per scan line (H)
Active lines per frame/field (V)
Minimum Back Porch in 3D mode
Minimum Front Porch in 3D mode
Input levels
R,B,G,Y — with sync
R,G,B — without sync
Pb,Pr
DC offset
Nominal impedance
Maximum return loss (VSWR)
* Input frequencies higher than the maximum panel refresh rate will be displayed at a lower rate.
Analog Video
(OPTIONAL)
Signal formats
Video standards
Composite/S-Video luminance bandwidth
Input level, Composite
Input level, S-Video, Luma (Y)
Input level, S-Video, Chroma (C)
DC offset
Nominal impedance
Maximum return loss (VSWR)
Sync
(INTERLACED OR PROGRESSIVE SCAN FORMAT)
Input level
DC operating range
Impedance
(for composite or separate H & V)
Sync type
Polarity
Maximum return loss (VSWR)
RS-232 Serial Input / Output
Number of connectors
Connector type
RS-422 Serial Input / Output
Number of connectors
Connector type
Wired Control Input
Optional wired keypad
2 RGBHV
2 video
P
b r (INTERLACED [non-3D] OR PROGRESSIVE SCAN FORMAT)
(NOTE: not available in 3D mode)
nd
(2 input via plug-in module)
(requires optional video decoder module)
15 – 120 kHz
23.97 – 120 Hz
10 – 160 MHz
Analog RGB or YP P
b r
640 – 2048 (1280 in 3D mode)
200 – 2000 (1024 in 3D mode)
350 ns (H) and 6 lines (V)
4 pixels (H) and 1 line (V)
1.0V ±2 dB
p-p
0.7V ±2 dB
p-p
0.7V ±2 dB
p-p
± 5V
75 ohms
1.2:1 dB @ 200 MHz
Composite (CVBS), S-Video (Y/C)
NTSC, NTSC 4.43, PAL, PAL-M,
PAL-N, PAL-60 & SECAM
5.5 MHz
1.0 V ± 3db
(including sync tip)
p-p
1.0 V ± 3db
(including sync tip)
p-p
630 mV nominal (burst)
p-p
± 5V
75 ohms
1.2:1 dB @ 6 MHz
0.5V – 5.0V
p-p p-p
0V – 5V
75 ohms nominal
• Separate H and V
• Bi-level or tri-level sync-on-green
• Bi-level or tri-level composite
Positive or negative
1.2:1 dB @ 200 MHz
3 (1 ntwrk in, 1 ntwrk out, 1 for switcher)
9 pin "D"
2
6-pin XLR
3-pin XLR connector