Mirage 2000 User Manual page 57

OPERATION
Copying or
Deleting Channels
3-20
Mirage 22000/4000/6000User's Manual
Abbrev.
4WH
4WV
SG
SR
5W
5WR
SVid
CVid
3LH
3LV
3LG
E3LH
E3LV
E3G
Dig
If you have more than a handful of channels, use
channels not visible in this initial display.
To copy, delete or edit any of the channels listed in the Channel Setup menu,
highlight the desired channel and do one of two things:
•
Press Func
channels. See Copying or Deleting a Channel below.
•
Press Enter
parameters) for the selected channel. See Editing a Channel Setup,
below.
'
TO COPY A CHANNEL
Func
press to go to the Channel Copy/Delete submenu. Select "Copy" and press
Enter —a new channel will be created. It is identical to original, which still remains,
but it is identified with the next available number from 01-99. If you change your
mind and do not want to copy the current channel, press
the previous menu. Copying channels is a quick method for creating numerous
channels, each of which can then be edited and adjusted for a variety of presentations
in the future.
Table 3.1. Abbreviations for Signal Type
Signal Type
Composite (4 wire) on HC input
Composite (4 wire) on V input
Sync-on-green
Sync-on-red
Separate H,V
Separate H,V swapped
S-Vid
Composite Video
Tri-Level on HC input
Tri-Level on V input
Tri-Level on green
European Tri-Level on HC input
European Tri-Level on V input
European Tri-Level on green
Digital
if you want to copy the selected channel or delete this or other
if you want to edit channel setups (i.e., non-image related
, highlight the desired channel in the Channel Setup menu, then
Figure 3.12. Copying A Channel
and to see the remaining
Exit to cancel and return to