Mirage 2000 User Manual page 40

OPERATION
distances than can RS-232 communications, but require RS-422 compatible
equipment.
AC LINE CORD INPUT —
The Mirage 2000 requires input power of 100-240 VAC,
50-60 Hz @ 9 amps (@ 100 V). The Mirage 4000 requires input power of 100-240
VAC, 50-60 Hz @ 11.5 amps (@ 100 V). The Mirage 6000 requires input power of
200-240 VAC, 50-60 Hz @ 8.5 amps (@ 200 V). Use the line cord provided with the
projector. See Section 5.
WARNING
Do not attempt operation if the AC supply is not within the
specified voltage and power range. Use the specified line cord.
STATUS/POWER LEDS —
Two LEDs (light emitting diodes) located in the lower right
corner of the rear connector panel indicate projector "Status" (top) and "Power"
(bottom). During normal operation, the "Power" light is steady green and the "Status"
light flashes green each time a key is pressed or when the projector receives a serial
command. Use the following as a guide:
Figure 3.2. Reading the Status LEDs
NOTE: A steady red power light accompanied by a coded pattern of red and yellow
flashes from the status light indicates an internal system error. Consult the rear LCD
display for an explanation, and see 3.12, Error Conditions. Should the problem
persist, contact a qualified service technician available through your dealer.
REMOTE WIRED KEYPAD CONNECTOR (3-pin XLR) —-
For optional tethered remote
control of the projector.
BUILT-IN KEYPAD —-
Alternative location for entering commands. NOTE: If desired,
the keypad can be inverted by a qualified service technician. Contact your dealer.
LCD STATUS DISPLAY —
Visual feedback for monitoring projector activities and
status.
3-3
Mirage 2000/4000/6000 User's Manual