Mirage 2000 User Manual page 115

MAINTENANCE
STEP 5
STEP 6
4-6
Mirage 22000/4000/6000User's Manual
Loosen the spring-loaded T-bolts
'
•
The lamp module is secured
to its adjustment plate with 3
large spring-loaded T-bolts
that lock in-and-out with a
90° turn (they are the largest
heads visible on the
adjustment plate). To remove
each T-bolt, use a Phillips
screwdriver to push and
turn each bolt 90°. The pin
behind each bolt will align
with its slot and pop the bolt
free. See right. NOTE: If you
can't access the bottom
screw in the 4000/6000,
decrease vertical offset.
Remove lamp and detach from terminal block
'
•
Pull the lamp module out slightly. Note that it is still attached to a "terminal
block" which connects to the lamp power supply via anode and cathode
cables–the lamp module cannot be fully removed yet.
•
Remove the single screw securing the lamp module to the terminal block. See
Figure 4.5. The lamp should now be fully free–refer to the recycling/disposal
instructions provided with the new lamp kit.
Figure 4.5. Detach lamp from terminal block
Detach the lamp from the terminal block only.
Figure 4.4. Loosen spring-loaded T-bolts
(SHOWN: 4000/6000 ORIENTATION.
IMPORTANT
Do not disconnect cables.
REVERSE FOR 2000)
(TOP VIEW)