Mirage 2000 User Manual page 5

INSTALLATION AND SETUP
STEP 6
2-2
Mirage 22000/4000/6000User's Manual
Adjust Image
'
(STANDARD NON-MOTORIZED LENS)
Adjust Image
(REQUIRES MOTORIZED LENS)
NOTE: This projector can be upgraded to include motorized lens controls.
With the input image displayed, press
If you've just installed the lens, select "Calibrate Lens" before making any
adjustments (see Section 3 for details). Then, with the Lens Control menu displayed,
use the keypad as shown in Figure 2.1 to focus the image clearly and, if a zoom lens
is present, to increase or decrease image size. If desired, adjust horizontal and/or
vertical offsets to shift the lens and image location—ranges are shown in 2.3,
Projector Position and Mounting.
•
ZOOM:
With the input image displayed, rotate the
textured ring on the lens barrel to increase or decrease
the image size (this requires a zoom lens). If you don't
have a zoom lens or you can't adjust the image
enough, the projector may not be positioned at the
proper throw distance for your screen size. Power
down, unplug the projector and move it towards or
away from the screen. See 2.3, Projector Position and
Mounting for details.
•
FOCUS:
At the lens opening, turn the focus tabs to
focus the image clearly.
•
OFFSETS:
Turn either or both of the knobs adjacent
to the lens if you need to align the image with your
screen—turn the top knob to raise or lower the image,
turn the bottom knob to shift the image left or right.
Re-check focus.
•
OTHER:
Press
parameters as described in Section 3.
Lens on any keypad.
Figure 2.1. Motorized Lens Adjustments
Menu to refine other display