Mirage 2000 User Manual page 49

OPERATION
3-12
Mirage 22000/4000/6000User's Manual
NOTE: Once Func
non-numeric entry until 2 digits have been entered or until 5 seconds of inactivity
have elapsed.
Use of the Func key within the menu system is noted with the appropriate topic
elsewhere in Section 3. For example, press
deletion or copying of a channel.
OSD (On-screen display)
OSD*
Press and hold OSD*
visible or invisible). Or press
guarantee the correct toggle direction (useful if you are unsure of the present status).
Note that invisible menus are fully functional.
NOTES: 1) With OSD on, you can still mute menus, error messages, slidebars, etc.
with the appropriate setting in the Menu Preferences menu. 2) The status of the
key is displayed in the LCD window on the rear panel of the projector.
Help
Help
Press Help for detailed information about any current menu and highlight. Press
again to exit. From presentation level, press
consisting of Using Help, Setup, Keys, Source (Input) Selection, Stat/Pwr LEDs and
Using 3D. Press
Test
Test
Press Test to display one of the available test patterns. Press
next available pattern in the sequence.
at any time to remove the current test pattern from the screen and return to
presentation level.
NOTE: For a complete list of available patterns, see the Communications submenu
description later in Section 3.
Keypad operating settings (protocols)
The remote keypad and the optional wired keypad both store keypad operating
settings (called protocols) in memory. In some advanced applications, such as when
you want to use two separate keypads to control two projectors independently, you
may want to override the original protocol set at manufacture (which is "A or B") for
one of the keypads. See section 2.10, Keypad Protocols and Conversion for complete
instructions.
Func
= Red
Func = Green
Func = Blue
Func = Red and Green
Func = Green and Blue
Func = Red and Blue
Func = All colors (
is pressed in presentation level, the projector will not respond to
for approximately 1 second to toggle menus on or off (i.e.,
OSD* followed immediately by
Exit to leave General Help and return to presentation level.
Test
Exit does the same thing)
Func in the Channel Setup menu to enable
ON or
Help to access the General Help menu
Test again to display the
will exit after the last pattern, or press
OFF to
OSD*
Help
Exit