Mirage 2000 User Manual page 119

MAINTENANCE
STEP 3
4-10
Mirage 22000/4000/6000User's Manual
align with the screws beyond, then insert the hex socket ball driver as shown.
See Figure 4.11.
•
IF MOTORIZED ZOOM LENS:
the zoom gear will be "skewed" away from the lens mount screws (see Before
You Begin instructions). Insert the hex socket ball driver through the holes at
approximately 30° to access each screw. Aim down for 4 o'clock screw, aim
up for 8 o'clock screw.
Figure 4.11. Accessing the Lens Mount Screws
Rotate Lens and Remove (Figure 4.12)
'
1. ROTATE THE LENS SLIGHTLY:
barrel counterclockwise until the screw heads align with the larger end of their
slots on the lens flange.
2. PULL LENS OUT:
and set aside.
Figure 4.12. Rotate Lens and Remove
As shown in Figure 4.11, the 3 access holes on
See below. Using both hands, rotate the lens
Carefully pull the lens assembly straight out of the projector
(FIXED LENS SHOWN)