Mirage 2000 User Manual page 18

YPbPr Signal
'
(COMPONENT VIDEO)
Composite Video
'
Connect a YPbPr signal (component video) to
Figure 2.14. Connecting YPbPr Signal
NOTES: 1) If, for some reason, the projector fails to recognize a YPbPr signal,
specify this Color Space option within the Image Settings menu. See 3.6, Adjusting
the Image. 2) Do not connect digital component signals (known as YCbCr) to
1
. Use the appropriate digital interface installed at
The video decoder input panel provides simultaneous connection of both a composite
INPUT 3
video source ( ) and an S-Video source (
If connecting a composite video source, use the Composite BNC connector or the
INPUT 3
RCA phono jack at
NOTE: If you want to loop a composite signal through to another projector or
display device, see Video Loop Through later in this section.
Figure 2.15. Connecting Composite Video
INPUT 1
INPUT 4
–do not use both as inputs. See Figure 2.15.
Mirage 2000/4000/6000 User's Manual
INSTALLATION & SETUP
as shown in Figure 2.14.
INPUT 2
..
).
INPUT
2-15