Mirage 2000 User Manual page 65

OPERATION
Image Settings
3-28
Mirage 22000/4000/6000User's Manual
and is correct in most cases. In rare instances, such as if your image exhibits tearing
or "flag-waving", increase the PLL loop gain setting as necessary. Or, if your image
is unstable and "breaks up", this may indicate that the PLL loop gain setting is either
too high or too low. PLL Loop Gain affects the current channel only.
Keystone
Not available in this projector.
Plug & Display (EDID)
NOTE: Requires optional DVI Input Module. Disabled for all other inputs.
By default, the Plug & Display option detects an incoming digital flat panel video
signal and displays it in the native resolution of your
projector. If you have additional daisy-chained projectors,
they will display in this resolution as well. If you want to
use a different resolution (for example, your graphics card
may not support the current resolution), select a different
Plug & Play setting from the list.
Tiling Setup
See 3.11, Using Multiple Projectors (Tiling Setup section).
'
Use options in the two-page Image
Settings menu to alter your image in
ways that do not affect its size or
position. Changes made to the Image
Settings menu are applied
immediately and are saved when you
exit the menu (press
Options not available for your
projector model appear dimly and are
disabled.
Contrast
(
SHORT CUT:
Press
slidebar.)
"Contrast" increases or decreases the
perceived difference between light
and dark areas of your image (0-100).
If contrast is set too high, the light
parts of the image lose detail and
clarity. If set too low, the light areas
will not be as bright as they could be
and the image will be dim. Start low and increase so that whites remain bright but are
not distorted or tinted, and that light areas do not become white (i.e., are "crushed").
For best results, keep close to 50.
Exit or Menu ).
Cont and adjust the
Figure 3.17. Image Settings Menu