Mirage 2000 User Manual page 111

MAINTENANCE
Lamp and Filter
Replacement
Power Cord
and Attachments
Ventilation
4-2
Mirage 22000/4000/6000User's Manual
'
Never attempt to remove the lamp housing directly after use.
The lamp is under great pressure when hot and may explode,
causing personal injury and/or property damage. Allow to cool
The arc lamp operates at a very high temperature and
pressure. Failure to allow the lamp to sufficiently cool prior to
handling could result in an explosion causing personal injury
and/or property damage. After turning the projector off it is
important that you wait at least five minutes before
unplugging it. This provides enough time for the internal lamp cooling fans to cool
the lamp and to automatically shut off. Cool completely before handling.
FILTER:
Replace the side filter every 1000 hours or sooner. If this filter is not
replaced, air flow may become restricted and cause the projector to overheat.
See 4.4, Replacing the Lamp and Filter for the complete replacement procedure.
'
Only use attachments or accessories recommended by Christie, such as the specific
power cord supplied. Use of other attachments or accessories with this projector may
result in the risk of fire, shock or personal injury.
Use only the AC power cord supplied. Do not attempt operation
if the AC supply and cord are not within the specified voltage
Do not allow anything to rest on the power cord. Locate the projector where the cord
cannot be abused by persons walking on it or objects rolling over it.
Operate the projector at the specified voltage only. Do not overload power outlets
and extension cords as this can result in fire or shock hazards.
The projector is equipped with a three wire plug having a third (grounding) pin. This
is a safety feature. If you are unable to insert the plug into the outlet, contact an
electrician to have the outlet replaced. Do not defeat the safety purpose of the
grounding-type plug.
'
Before unplugging the power cord, make sure the internal
lamp cooling fans have shut off. The fans automatically shut
off when the projector has adequately cooled down.
Slots and openings in the projector provide ventilation. To
ensure reliable operation of the projector and to prevent overheating, these openings
must never be blocked or covered. The projector should never be placed near or over
a radiator or heat register. The projector should not be placed in an enclosure unless
proper ventilation is provided.
WARNING
completely.
WARNING
Use only lamps supplied by Christie.
WARNING
Use only filters supplied by Christie.
WARNING
and power range. See Section 5.