Mirage 2000 User Manual page 64

1. Optimize Pixel Tracking and jot down the
value.
2. Optimize Pixel Phase
3. If the image is still too noisy, return to Pixel
Tracking and "mis-adjust" so that 2 vertical
bands of noise appear, separated by a good
center band. See right.
4. Adjust Filter to maximize the width of the good
area. See right.
5. Return Pixel Tracking to its correct setting from
Step 1.
6. Readjust Phase.
NOTE: "Filter" affects only the current signal.
H-Position
(
SHORT CUT:
Position
Press
This option moves image right or left.
NOTES: 1) The value shown represents where the approximate center of the image
lies in relation to the total number of pixels available horizontally. This varies widely
according to the signal—watch the image while adjusting 2) Range of adjustment is
limited in 3D mode.
V-Position
(
SHORT CUT:
Press Position
This option moves the image up or down.
NOTES: 1) The value shown represents where the approximate center of the image
lies in relation to the total number of pixels available vertically. This varies widely
according to the signal—watch the image while adjusting. 2) Range of adjustment is
limited in 3D mode, and affects 3D performance. See 3.10, 3D Images for details.
Lens Control
(REQUIRES MOTORIZED LENS UPGRADE)
(
SHORT CUT:
Press Lens
For a full description of the Lens Control submenu, see 3.3, Using the Keypad (
key) and 2.8, Zoom, Focus and Lens Offset.
Blank: Top, Bottom, Left or Right
These slidebars blank (turn to black) the top, bottom,
left, or right edge of the image so that any unwanted
information is cropped from view. For example, when
displaying native size video you may want to blank
out a few of the top lines.
PLL Loop Gain
This control changes the relative offset to the default gain. The default PLL (Phase
Lock Loop) Gain setting of 10 is set automatically with a Pixel Tracking adjustment
and adjust the top slidebar.)
and adjust the bottom slidebar.)
to activate the Lens Control submenu.)
Mirage 2000/4000/6000 User's Manual
OPERATION
Lens
3-27