Installing Your Computer; Figure 7: Computer And Power Cables - SMART Board 2000i Installation Manual

Installing Your Computer

To connect your computer
1. Slide the computer into place on the bottom storage shelf, above the computer straps, and
then secure the straps around the computer.
NOTE: The straps allow you to roll the unit from room to room without removing the computer.
However, these straps will not secure the computer in place during unit shipment. If you ship
the unit, remove the computer first.
2. Locate the bundle of labeled cables (to the right of the projector) hanging down towards the
storage tray.
Computer 1 Serial (Female)
3. Connect the Computer 1 Video Out cable to the Monitor Video connector.
4. Connect the Computer 1 Audio cable to the Audio Line OUT connector.
5. Connect the Computer 1 Serial cable to an available COM port.
NOTE: To connect a computer that has no available serial port, connect the SMART USB
adapter (order number USB-ADP) between the Computer 1 Serial cable and the USB port on
the computer.
6. Connect the Mouse and Keyboard cables (not supplied) to the PS/2 mouse port and the PS/2
keyboard port on the computer.
To connect power:
1. Connect the Computer AC
2. Connect the 2000i AC
connect this AC cord to an available power outlet or power bar (not supplied).
2000i AC (Male)
(Connect to female country-specific AC cable)

Figure 7: Computer and Power Cables

to an available power outlet or power bar (not supplied).
cord to the country-specific AC cord in the accessory box. Then
2000i Installation Guide
Computer 1 Audio
Computer 1 Video (Male)
7