Installing Your 2000I; Setting Up The 2000I; Figure 4: A Locked And Unlocked Caster; Figure 5: Extending An Anti-Tip Foot - SMART Board 2000i Installation Manual

Installing Your 2000i

This section of the manual describes how to:
•
set up the 2000i (page 5)
•
install and connect the host computer (page 7)
•
adjust the projected image (page 10)
•
connect the videoconferencing/laptop shelf (page 17)
•
install SMART Board software (page 21)
•
connect a guest laptop (page 23)
•
connect a VCR or DVD player (page 26)
•
connect an external sound system (page 27)
•
connect an external projector or monitor (page 28)

Setting Up the 2000i

1. Remove the unit from its shipping carton (follow the Unpacking Instructions).
2. Unpack the remaining contents of the shipping carton and wheel the unit to a location that's
within reach of a power source.
NOTE: Leave enough space around the unit to comfortably perform the following assembly
and connection procedures.
3. Lock the casters by pressing down on the caster-lock tab; unlock the casters by pressing up on
this tab, as shown in the figure below.
4. Extend all four of the anti-tip feet. You'll see two holes on the outer side of each leg. Depress
the locking ball on the inner hole, and then pull the leg out until the locking ball engages in the
outer hole.

Figure 4: A Locked and Unlocked Caster

Locking Ball in the
inner hole

Figure 5: Extending an Anti-Tip Foot

2000i Installation Guide
Locking Ball in the
outer hole
5