Table of Contents
Advertisement
Powering up the 2000i
1. If the projector is not switched on, toggle the main power switch on.
2. At the front of the 2000i, press the power button on the computer.
3. Turn on the projector lamp by pressing the Projector Standby button on the Control Panel (to
the right of the pen tray). The LED indicator beside this button should blink fairly quickly for 90
seconds, and then it should remain steadily illuminated when the projector lamp has powered
up.
OR
Press the Lamp On/Off button on the projector remote control (or on top of the projector)
to turn on the projector lamp.
After a 30-second lamp warm-up period, the screen displays an image.
You should now adjust the computer power settings and image alignment, install the
SMART Board software CD, configure the COM port, and perform a brief orientation
procedure. To do this, follow the procedures described in the pages that follow.
NOTE: You should leave the computer and projector main power switch on at all times (so
the projector is either in use, with the lamp illuminated, or in standby mode). However, you
can set the computer to save power during periods of inactivity. The following section
describes how to do this.
8
Figure 8: Main Power Switch on Projector
LED Indicator of
Lamp Status
Figure 9: Projector Standby Button and LED Indicator
2000I Installation Guide
Main Power Switch
Projector Standby Button
Advertisement
Table of Contents
