Table of Contents
Advertisement
Orientation > Ceiling Rear to orient the projected image for desktop (as opposed to ceiling)
rear projection
Background > Logo to select the SMART logo to serve as the standby screen
6. Click the Page 4 tab and select:
Auto Adjust to automatically determine the best resolution for the current RGB input signal,
compensating for resolution differences among input devices (such as guest laptops)
Power Management to automatically shut down the projector when no RGB input signal is
received from the computer (or any other source). This helps conserve the life of your projector
lamp.
Idle Mode to allow the RGB OUT connector to output RGB signal during Idle mode
7. De-select Built-in Speaker to mute the projector's speakers
8. Click the Page 6 tab and select:
Default Source Select > Select > RGB1 to make RGB1 the default display source each time
the projector starts up
9. Select Projector Options > Lamp Setting > Lamp Mode > Normal to set the projector lamp
to optimal brightness for the 2000i.
10. Select Projector Options > Auto Functions.
11. De-select Focus because the custom lens of the projector only permits manual focus
adjustment.
12. Select Projector Options > Screen > 4:3 to enable a standard aspect ratio.
13. Click OK to save these settings.
2000i Installation Guide
39
Advertisement
Table of Contents
