Table of Contents
Advertisement
Cleaning: Filter and Clearing the Filter-Cleaning Message
Clean the air-filter sponge with a vacuum after every 100 hours of operation (more often in dusty
conditions) as described on page E-54 of the NEC MT1065/MT1060/860 User's Manual.
A "Please Clean Filter" message from the projector will appear on the bottom of the screen after
every 100 hours of operation. However, after cleaning the filter this message will not automatically
disappear. You must use the projector remote control to clear the filter usage meter, as follows:
1. Press the Menu button on the projector remote control.
2. Select Advanced Menu > Projector Options > Menu > Setup. Click the Page 4 tab and then
click the Clear Filter Usage Meter button.
The meter will be returned to zero. You won't receive another "Please Clean Filter" message
for another 100 hours.
Replacing the Projector Lamp and Filter
Replace the lamp when you see this message "The lamp has reached the end of its usable life.
Please replace the lamp." To do this, order a replacement standard lamp or extended life lamp
from your NEC or SMART dealer.
NOTE: Your projector is shipped with a NEC MT60LPS extended life lamp.
In general, you should replace your projector lamp after 4000 hours (extended life lamp) or 2000
hours (standard lamp/normal mode). The projector will turn off automatically and go into standby
mode after 2100 hours (standard lamp/normal mode) or 4100 hours (extended life lamp).
To find out how many hours of lamp use remain, go to the projector menu and select Help >
Information > Page 4 tab. Replacing the used lamp with a new lamp automatically clears the lamp
usage hours. When you replace the projector lamp, you should also replace the projector filter.
You'll automatically receive this filter with the replacement lamp.
Only replace the projector lamp with the NEC MT60LP standard lamp or the NEC MT60LPS
extended life lamp available from NEC or SMART. Do not use any other lamps. You'll find
instructions for replacing the lamp on page E-53 in the NEC MT1065/1060/860 User's Manual.
WARNING
After you turn off the projector, allow at least one minute to elapse before you
unplug it. Do not touch or replace the projector lamp (which will be very hot)
for at least an hour.
Après avoir éteint le projecteur, attendez au moins une minute avant de le
débrancher. Attendez au moins une heure avant de toucher ou de remplacer
la lampe du projecteur (qui sera très chaude).
Stecken Sie den Projektor für mindestens eine Minute nach dem Abschalten
nicht aus. Berühren oder ersetzen Sie die Projektorlampe (die sehr heiß sein
wird) nicht vor Ablauf einer Stunde.
プロジェクターの電源を切った後、最低でも 1
分間はプロジェクターのプラグを抜かないでください。プロジェクターのラ
ンプは非常に熱くなりますので、最低でも 1
時間は触ったり交換したりしないでください。
2000i Installation Guide
35
Advertisement
Table of Contents
