Basic Operations; Starting Up The 2000I - SMART Board 2000i Installation Manual

Basic Operations

This section shows you how to:
•
Start up and shut down the 2000i (page 29)
•
Adjust the height of the interactive whiteboard (page 31)
•
Adjust the volume (page 33)
•
Adjust projector settings (page 33)
•
Change the projector display source (page 34)
•
Use the interactive whiteboard (page 35)

Starting Up the 2000i

The projector in your 2000i should always remain on; only the power to the projector lamp is
switched on and off at the Control Panel. For greater ease of operation, you should also keep the
computer on all the time. With the projector and computer always on, starting up the 2000i requires
only that you restore power to the projector lamp (by pressing the Projector Standby button on the
Control Panel) and then enter your user name and password at the logon screen.
NOTE: To preserve the computer's hard drive(s) and the projector lamp, you may want to put the
computer hard drive and monitor into standby mode. Refer to page 9 for instructions.
To start up the 2000i
1. If the screen is black, press the Projector Standby button on the Control Panel to power up
the projector lamp. The LED indicator beside that button should blink moderately fast for
approximately 30 seconds, and then remain illuminated when the lamp is fully powered up.
2. If you see a logon screen, use the connected keyboard to enter your logon ID and password,
and then press the OK button.
OR
If the screen turns from black to blue (with a SMART logo) – and no logon screen appears –
you may need to power up the computer or restore it from a standby setting. Open the front
door and turn the computer on, or press the reset button (if required).
3. To connect a guest laptop, refer to page 23.
The table on the next page summarizes the possible startup scenarios and what you should do in
each situation.
2000i Installation Guide
27