Table of Contents
Advertisement
To re-calibrate the cameras
1. Press the SMART Board icon in the system tray, and select Control Panel.
The SMART Board Control Panel opens.
2. In the Boards tab, press the Advanced button.
The Edit Advanced Board Settings dialog box opens.
3. Press the DViT Settings tab.
4. Press the Calibrate button.
The four-point calibration screen appears.
5. Press the center of each target and hold until you hear a beep.
After you press the final target, a message appears, followed immediately by the orientation
screen.
6. Complete the orientation procedure.
NOTE:
You will not hear a beep after pressing each target on the orientation screen.
7. Press OK.
The 2000i is now ready for use. Use your finger to open and control programs. Use a stylus from
the pen tray to write in virtual, electronic ink. Capture or print the annotations that you want to save
with the touch of a toolbar button. Display the contents of a guest's laptop computer or show a
video presentation from a connected VCR or DVD player.
Connecting a Guest Laptop
If you don't have the X-Port 20 switch option, you'll need the following cables to connect a guest
laptop to the 2000i:
•
An HD15-to-BNC video cable for the laptop video
•
a 3.5 mm (both ends) audio cable for the laptop audio
NOTE: Without the X-Port 20 switch option, you cannot control the laptop display by touching the
screen, nor will you be able to switch between the host computer and a guest laptop
Controlling a Guest Laptop by Touching the Screen
You can control a connected laptop presentation by touching the screen only if you:
•
purchase and install the X-Port 20 switch option for the 2000i
•
install SMART Board software on the laptop
The X-Port 20 unit is an RS-232 serial switch that provides a serial connection from the laptop,
enabling the laptop user to both write over top of the displayed laptop image with a pen tray stylus
and control the contents of the laptop by touching the screen. In addition, it allows you to switch
between the laptop, the resident computer and a VCR/DVD player using the Control Panel at the
front of the 2000i.
Complete instructions for installing the X-Port 20 switch and connecting a guest laptop are in the X-
Port 20 Switch Option Installation Guide that comes with the option kit.
To connect a guest laptop (without the X-Port 20)
1. Power down the projector.
2. Connect the HB15 end of HD15-to-BNC video cable to the Video port on the laptop.
2000i Installation Guide
21
Advertisement
Table of Contents
