Table of Contents
Advertisement
Startup Scenarios
If your 2000i is situated in a multi-user room, you may sometimes find the unit in a non-operational
state. The following table describes what you may need to do to restore the 2000i to a fully
operational state.
What You See
•
Screen is black
•
Standby LED is blinking very
slowly
•
SMART "No Source Signal"
screen
•
Standby LED is steadily
illuminated
•
Screen is black
•
LED indicator is blinking
rapidly
•
Screen is black
•
LED is blinking rapidly
•
None of the Display Source
LEDs are illuminated
•
Logon Screen
•
LED indicator is blinking very
slowly
•
Projector Standby button has
been pressed
•
All the LED indicators on the
Control Panel are blinking
28
What You Should Do
The projector is in standby mode (with lamp off).
1. Press the Projector Standby button on the Control Panel. The LED
indicator flashes moderately fast, and, after approximately 30
seconds, either a blue SMART "No Source Signal" screen appears or
the screen is restored to its pre-standby state.
If the SMART "No Source Signal" screen appears:
1. Touch the screen, press the Display Source button or press a key on
the connected keyboard. If the previous user logged off, the logon
screen appears. Otherwise, the screen returns to its pre-standby state.
2. Log on as usual (using the connected keyboard).
The projector lamp is powered up, but the computer is either off or in
standby mode, or you've selected an inactive display source.
1. Press a key on the connected keyboard to activate the computer. The
logon screen appears.
OR
Press the Display Source button to change to an active source.
If the SMART "No Source Signal" screen remains:
1. Turn the computer on (or press the computer reset button). The logon
screen appears.
2. Log on as usual (using the connected keyboard).
No action is necessary. The projector lamp is in the process of powering
up. The logon screen appears after approximately 30 seconds.
The projector lamp is in reversible standby mode. Press any button on the
Control Panel to instantly restore the image, or allow standby to continue
for five minutes until the LED indicator starts blinking slowly. After an
additional 90 seconds, the projector lamp will reach full standby mode. At
this point, follow the first set of instructions in this table to restore the 2000i
to an operational state.
The projector lamp is still on, so you can log on as usual (using the
connected keyboard).
Problems with the projector are interfering with the normal projector lamp
warm-up. Examine the projector status LED indicator, and then consult the
troubleshooting section of the NEC MT1065/MT1060/MT860 User's
Manual.
The system can't detect a projector. Check the NEC
MT1065/MT1060/MT860 User's Manual to make sure the projector is
connected properly.
2000I Installation Guide
Advertisement
Table of Contents
