Table of Contents
Advertisement
Connecting a VCR or DVD Player
You'll need the following cables to connect a VCR or DVD player to the 2000i:
•
an RCA composite video cable or an S-video cable
•
standard red and white RCA audio cables
To connect a VCR/DVD player to the 2000i
1. Power down the projector.
2. Connect the yellow RCA video connector on an RCA composite video cable (not provided) to
the Video Output jack on the VCR/DVD player. This jack may be labeled "To Monitor."
3. Plug the other end of the cable into the Video IN connector on the projector.
Figure 29: Connecting the Video Cable from the VCR/DVD Player to the Projector
NOTE: If you're using an S-video cable, connect it to the S-video Out connector on the
VCR/DVD player, and then plug the other end directly into the S-video IN on the projector.
4. Connect standard red and white RCA audio cables (not provided) from the RCA Audio outputs
on the VCR/DVD player to the two Auxiliary Audio IN jacks on the rear of the 2000i. Keep
your right and left channel connections correct for stereo sound.
24
Composite Video
Cable from VCR or
DVD Player
C o m p
r 2
u t e
A u x
i l i a r y
A u d
i o
A u d
i o
A u d
i o I n
O u t
Figure 30: Connecting the Audio Cable to the 2000i
2000I Installation Guide
Video IN
Computer 2
Aux iliary
Audio
Audio
Audio In
Out
Connect
red and white RCA audio
cables
here
Advertisement
Table of Contents
