Introduction; Problems During Boot - Micron ClientPro XVI User Manual

Occasionally while setting up and configuring a computer system, an error may occur or
an important element may be forgotten. This section provides information regarding the
most frequently encountered problems, as well as many quick and simple solutions. If you
continue to experience problems and this section fails to provide solutions, please feel
free to contact Micron technical support (see Appendix A: Contacting Technical Support).

Problems During Boot

Problem
When the power switch is turned on, the system does not power up (i.e., the
exhaust fan does not run, the power indicator light is not illuminated, the hard
disk does not begin to spin, etc.), and no audible "beep" is heard.
Possible Cause
The power cable is unplugged or defective.
Voltage switch is improperly set.
No power at outlet.
Bad power supply.
Solutions
Check to ensure the power cable is plugged in correctly and firmly. Try a
second power cable, if available, or test the cable for continuity. Replace
original cable if it is found to be defective.
Check the red voltage switch (located at the rear of the unit near the fan)
and ensure that it is set for the proper voltage (115V in the U.S. and
Canada).
Check the outlet with another appliance (e.g., a lamp).
If a surge suppresser or Uninterruptable Power Supply (UPS) is
being used, temporarily bypass the surge suppresser and plug
the unit directly into the wall outlet. The surge suppresser or
UPS may be faulty.
4-2
Micron ClientPro X

Introduction

User's Guide
VI
Micron Electronics, Inc.