Removing Simm Modules - Micron ClientPro XVI User Manual

Alignment hole
Post peg
Be sure the module is centered
and connector pins are aligned and
FULLY SEATED.

Removing SIMM Modules

To remove SIMM modules, simply reverse the above procedure with the following differ-
ences. Using the thumbs of both hands, gently pry the locking tabs apart so they no longer
hold the module in the socket. While holding the tabs apart, gently pull the module backward
to clear the tabs (this should put the module at an angle to the socket). Carefully remove
the loose module from the socket.
2-14
Micron ClientPro X User's Guide
VI
When the module has been
locked in place, be sure both
silver tabs on each side of the
socket are fully closed.
Figure 2-11. SIMMs with Keyed Notch
Micron Electronics, Inc.
Keyed
Notch