Micron ClientPro XVI User Manual page 46

Primary IDE Master/Slave and Secondary Master/Slave
Reports if a hard disk is connected to the system. When selected, this brings up the
Hard Disk Configuration subscreen.
IDE Device Configuration
Used to manually configure the hard drive or have the system auto configure it.
The options are Auto Configured and User Definable. The default is Auto
Configured. If you select User Definable then the Number of Cylinders, Number
of Heads, and Number of Sectors items can be modified.
Number of Cylinders
If Hard Disk Type is set to User Definable, you must type the correct number of
cylinders for your hard disk. If Hard Disk Type is set to Auto Configured, this
reports the number of cylinders for your hard disk and cannot be modified.
Number of Heads
If Hard Disk Type is set to User Definable, you must type the correct number of
heads for your hard disk. If Hard Disk Type is set to Auto Configured, this
reports the number of heads for your hard disk and cannot be modified.
Micron Electronics, Inc.
Chapter 3: The BIOS Setup Program
Figure 3-3. IDE Master or Slave Screen
3-7